|
|
|
|
|
|
A Patented Small Size, X-ray Film Carrier/Transport for
Veterinary Medicine
The new FilmTran™ Small Size X-Ray Film Carrier/Transport for Veterinary Medicine
Is designed to transport small size X-ray film through a larger processor , and then be
Used as a viewing card. The Carrier/Transport will save the expense of purchasing and
Operating two separate processors.
The card is constructed of a sheet of developer chemical and roller resistant material with
Single or multiple windows cut into it to receive smaller size X-ray film used in veterinary
Medicine.
The Carrier/Transport is also available in clear polyester with a clear adhesive to use only
As an existing X-ray film viewing card that allows a view of the entire X-ray.
The windows have a protected pressure sensitive frame which, when the adhesive is
Exposed, allows the film to be securely attached. The frame is protected by a PSA liner
Which is slit for easy removal, even in the darkroom.
FilmTran™ Film Carrier/Transport for Veterinary Medicine is available at a very low cost
And is effective for use in virtually any size film processor.
|
|
|
|
|
|
|
|
|
|
|
|
Because of its construction , the
Carrier/Transport is developer
Chemical and roller resistant. It can
Be used in virtually any size film
Processor, thereby saving the cost of
Purchasing and maintaining two
Different processors., one for the
Large film and another for small film.
The FilmTran™ Carrier/Transport has
A single or multiple 3"x2-1/4"
(Kodak Size #4 or 1-5/8"x1-1/4"
(Kodak Size #2) or 15/16"x1-9/16"
Windows cut to receive the film used
In Veterinary Medicine.
For viewing purposed only, FilmTran
Also makes a carrier constructed with
A clear window and clear adhesive to
Allow viewing of the complete X-ray,
With no opaque edges that might
Obscure the outer perimeters of the
Film. The card is imprinted with
Spaces for writing pertinent
Information such as I.D. numbers
Doctors or patients name.
|
|
|
|
|
|
|
|
|
|
How to use the FilmTran™, X-Ray Film Carrier.
After the film has been exposed.
Remove all wrappers, if any (in the darkroom)
Remove the protective liner from around the
window to expose the adhesive
Place film onto the window frame then press and
glide gently, but firmly, with the thumb around the
frame to insure good contact to the adhesive.
You may use a hand roller and pad part No. RP1
or you may feed it through a pressure roller
device (Bisco Film-Set) before sending
through the processor.
Feed through the film processor.
Use Carrier/Transport with film for viewing just
as it comes out of the processor.
|
|
|
|
|
